EXTender
TM
7000 Installation Guide
Page 32
Setting the Sync Rate
1.
Access the
WAN 1
or
WAN 2
Sync_Setup
Menu
using the following path:
MI Path
Configuration->WAN 1 or 2->Sync_Setup
The following menu appears.
Figure 3-9: Sync Rate
2.
Press the
→
key to the
Sync Rate
parameter and type in the correct Sync rate. This parameter sets the
synchronous data transfer speed of the WAN port and must match the network device speed.
Note: This Sync Rate information, displayed in bytes, must be obtained through the network device doc-
umentation.
3.
Press the
←
key to accept changes and go back to the Configuration Menu
.
4.
Press the
↓
key to the
Save
parameter.
5.
Press
Enter
to save changes to the active config (.
rem
) file.
Setting the Mode (Signaling Protocol)
1.
Access the
WAN 1
or
WAN 2
Menu
using the following path:
MI Path
Configuration->WAN 1 or 2
2.
The WAN menu appears. Press the
→
key to access the parameters.
Figure 3-10: Setting Mode for WAN 1 or 2
3.
Press the
↓
key to the
Mode
parameter. This parameter must match the protocol used by the network
device connected to the WAN port. Press the
→
key to scroll through the available protocols.
4.
Press the
←
key to accept changes and go back to the Configuration Menu
.
5.
Press the
↓
key to the
Save
parameter.
6.
Press
Enter
to save changes to the active config (.
rem
) file.
