EXTender
TM
7000 Installation Guide
Page 49
5.
(All channels in use) If all 24 channels are used, set the default menu to Frame Relay and set all of the
individual DS0 channel menus to use <default>.
Figure 3-33: Frame Relay - All Channels in Use
6.
(Less than 24 channels) If
less
than 24 channels are being used assign a subset of DS0 channels by
either:
•
Set the default to Frame Relay and then assign all non-Frame Relay DS0 channels to something
else, such as dialup
Figure 3-34: Frame Relay - Less than 24 Channels in Use
or
•
Set the default to something other than Frame Relay and then manually set each DS0 channel
menu to use Frame Relay. Use the channels with higher numbers (17-24) as Frame Relay channel
assignment occurs sequentially (from the lowest to the highest). This will help eliminate assigning a
channel that has already been used.
Verifying Frame Relay Parameters
To verify the Frame Relay parameters are correct monitor the Frame Relay status screen to see if LMI pack-
ets are being exchanged with the Frame Relay network. Once enough packets are exchanged the status
screen will change to indicate that the network connection is
UP
.
Procedure
1.
Use the arrow keys to access the Frame Relay Status menu, as shown below:
Note
: The Frame Rrelay stats are for the Voice PVC only.
MI Path
Status->Connect->Frame Relay
