EXTender
TM
7000 Installation Guide
Page 47
5.
Set the Maximum Bandwidth to the specified amount of guaranteed bandwidth (measured in bits per
second) on a Frame Relay service. Use MCK’s Bandwidth calculator.
6.
Repeat steps 3 -5 for each additional PVC (ie. Add/Drop PVC(s)).
7.
Use the
←
and
↓
keys to return to the
Save
option.
8.
Press
Enter
to save changes to the active config (.
rem
) file.
T1/PRI Port (WAN3) Frame Relay Parameters
This section provides instruction for the configuration of the Leased TI line that is connecting the EXTender
7000 to the Gateway.
1.
Set the
Clock Source
parameter to
T1PRI_Port1
.
•
Set to Port 1 if the network is providing timing, or Port 2 to use the EXTender 7000 for the timing
source.
Note
: Point-to -Point (RVP_Direct) T1’s
DO NOT
provide timing.
Figure 3-30: Clock Source
2.
Go to the
T1/PRI Port
Setup Menu to perform the basic setup for the T1/PRI ports and channels. This
menu is located in the WAN submenu structure, and can be accessed using the following path:
MI Path
Configuration->WAN->T1/PRI_Port(WAN3)->T1/PRI_Port_1
The following menu appears:
Figure 3-31: T1/PRI Port (WAN3) Parameters
3.
Set the
Enabled
parameter to
Yes
.
4.
Set the
Mode
parameter to
T1
.
5.
Ignore the following parameters, as they do not apply to Leased T1 configurations:
Node Type
,
Switch
Type
, and
Dialback DN
.
6.
Set the
Line Code
and
Framing
parameters with values provided by the Telco company (CO).
7.
Select a value for the
Line Build Out
parameter to attenuate the signal before it leaves the extender.
Use a value recommended by the Telco company (CO).
