EXTender
TM
7000 Installation Guide
Page 33
Setting the Interface Type
1.
Access the WAN 1 or WAN
2 Menu using the following path:
MI Path
Configuration->WAN 1 or 2
2.
The WAN menu appears. Press the
→
key to access the parameters.
3.
Press the
↓
key to the
Interface Type
parameter, which has the following values:
Notes:
DTE is typically used to connect to a third party CSU/DSU for RVP_Direct (Serial RVP) installations.
DCE is typically used in Add/Drop configurations (connecting to an EXTender 6000 or a Router). In DCE
installations, you must use the 25 pin Female-to-Female crossover cable (DB-25, RS-530) that we pro-
vide.
4.
For most connections, you will want to set the this parameter to
DTE
.
Figure 3-11: Interface Type
5.
Press the
←
key to accept changes and go back to the Configuration Menu
.
6.
Press the
↓
key to the
Save
parameter.
7.
Press
Enter
to save changes to the active config (.
rem
) file.
Value
Description
DCE
The WAN port on the EXTender 7000 connects to a DTE device.
DTE
The WAN port on the EXTender 7000 PBXgateway II connects to a DCE
device.
