EXTender
TM
7000 Installation Guide
Page 29
Serial RVP (RVP_Direct) via WAN Configuration
The following pages provide step by step instructions for configuring a basic Serial RVP installation using
the WAN ports of the EXTender 7000. To configure the system, you will set various parameters in the Man-
agement Interface (MI). For more information please refer to the EXTender 7000 User’s Guide.
After installation, your system should be connected as shown in the figure below:
Figure 3-6: Serial Installation via WAN Ports
Prerequisites for Configuration
•
The PBXgateway II (at the corporate site) and the EXTender (at the branch office) must be installed
properly and the network link between both devices must be operational.
•
It is recommend that the network administrator assign an IP address for both units for remote configura-
tion and administration.
Configuration Steps
You must ….……
to…………
Default settings
Set Connect Parameters
Select the network type and set parameters
relating to that network type.
RVP Direct
Setup the WAN ports
Enable WAN ports to connect to network
device.
WAN 1 - Enabled
Set the Sync Rate of the WAN port
Match the data rate (sync rate) of the net-
work device.
512,000 kbps
Set the mode (interface type) of the
WAN port. (v.35, RS-232, RS-530)
Match the interface type of the network
device.
Sync-V.35
Punch Block
Public
DSU/CSU
DSU/CSU
PBX
Branch Office
Corporate Facility
Punch Block
PBXgateway II
EXTender 7000
CSU/DSU
Connects via
WAN Port
Router
Router