EXTender
TM
7000 Installation Guide
Page 39
for Local Dialing
•
To support Local Dialing, the EXTender 7000 unit uses UDP ports 16384 to 16640. The port numbers
start at 16384 and increment by 1 to the total number of ports used. For example, if 3 telephones need
to make local calls, then ports 16384, 16385, and 16386 would need to be opened.
To ensure access to these ports, you should open all the ports in the range (ports 16384 to 16640).
•
The PBXgateway II unit uses port 2698 TCP/UDP.
RVP_IP - Configuration
Connect Parameters - RVP_Over_IP
The EXTender 7000 utilizes a LAN connection to provide remote user connectivity. This means that the LAN
port is plugged into an IP network and is assigned an IP address. The LAN port labeled AUX LAN is used
for remote administration purposes only (i.e. a Telnet session). The IP Destination (the IP address of the
PBXgateway II) must be entered within the MI of the EXTender.
Procedure
1.
Access the
Connect
menu using the following path:
MI Path
Configuration->Connect
2.
If necessary, use the
→
key to access the
Type
parameter. Set this parameter to RVP_Over_IP.
Figure 3-18: Connect Menu
3.
Use the arrow keys to access the RVP_Over_IP submenu.
MI Path
Configuration->Connect->RVP_Over_IP
You Have to...
In order to...
Set the IP Parameters.
Allow the EXTender 7000 to communicate with the PBXgateway II over
an IP network.
Disable both WAN ports.
Disable ports that are not used for RVP_over_IP.
Configure the EXTender 7000.
Set the required IP and Connect parameters.
