MB Connect Line mbNET.rokey RKH 210, Manual

Page: 261 / 324

Designation Description
Function Selection field for the condition for switching the selected output:
•
Off
Select these settings, if the selected output should not be switched.
•
On by malfunction
Select this setting in the event of a device fault if the selected output should be
set to signal level 1.
•
On by internet connection
Select this setting if the selected output should be set to 1 when connected to
the Internet.
For example, an active Internet connection can thus be signalled by a lamp
connected to the corresponding output.
•
On by VPN connection
Select this setting if the chosen output should be set to 1, once a user is con-
nected to the mbNET via an active VPN connection.
If the active connection is lost, the output is switched off again.
For example, an active Internet connection can thus be signalled by a lamp
connected to the corresponding output.
•
On by any active User-Cloudserver connection
Select this setting if the selected output should be set to 1, as soon as at least
one mbCONNECT24 user has an active connection to the mbNET.
If the active connection is lost, the output is switched off again.
For example, an active Internet connection can thus be signalled by a lamp
connected to the corresponding output.
Clicking on "Save” temporarily saves the current entries/changes.
But the changes are not yet enabled.
Clicking on "Close” discards the current input/changes.
N O T I C E
Temporary stored settings/changes are saved until a reboot of the router.
Only after you confirm via “Apply Changes", will the changes be applied (activated) and stored permanently.
Clicking on “Apply changes” will apply all stored settings/changes and store them perma-
nently on the router.
"Clear Changes” will reset/discard all temporarily stored settings/changes.
Alarm Management | Page 261 of 324