MB Connect Line mbNET.rokey RKH 210, Manual

Page: 163 / 324

Designation Description
Station address of
the Routing Gateway If routing function is enabled via RFC1006, you must enter the address of the rout-
ing gateway here. (Address 14 in the example below).
N O T I C E
If a bus participants (slave) is to be accessed on a subordinate station that is not directly connected to
the network, the station address of the PLC must be registered as a routing gateway in the router with the
gateway (master).
Example:
If the PLC (master) is connected to the router (address 13) via MPI-bus (address 14), a participant (address
5) is connected to the Profibus of the master (address 4). The routing must be enabled in order to now
access the Profibus using the router (address 13) via MPI on the participants with address 5 on the Profibus.
Protocol: VCOM LAN/PC Adapter
In the case of protocol choice VCOM LAN2/PC Adapter, the PG/PC interface must be set to a PC adapter
(MPI/PROFIBUS). If the bus speed is higher than 1.5 MBit/s, this must be specified manually.
Designation Description
Protocol Protocol selection field. You can choose between a connection via MPI/Profibus net-
work driver or VCOM LAN2/PC adapter.
Protocol MPI/PROFIBUS baud rate selection field.
Serial (serial port COM) | Page 163 of 324