MB Connect Line mbNET.rokey RKH 210, Manual

Page: 133 / 324

Clicking on "Save” temporarily saves the current entries/changes.
But the changes are not yet enabled.
Clicking on "Close” discards the current input/changes.
N O T I C E
Temporary stored settings/changes are saved until a reboot of the router.
Only after you confirm via “Apply Changes", will the changes be applied (activated) and stored permanently.
Command set for remote control of the mbNET via SMS
Command Note
INET START
or
INET STOP Control of the internet connection of the Industrial router. Note that
only one set of active internet connections can be controlled by the
established industrial router.
IPSEC START [connection name]
or
IPSEC STOP [connection name]
PPTP START [connection name]
or
PPTP STOP [connection name]
OPENVPN START [connection
name]
or
OPENVPN STOP [connection
name]
No matter which VPN type has been selected, the connection name
must always be specified accordingly(example: OPENVPN START
Wizard).
Furthermore, you need to note that the connection name is case sen-
sitive!
REBOOT The industrial router will restart with this command. Please note that
your industrial router will not execute any other commands during
this time.
OUT ON
or
OUT OFF With the command OUT ON [output no.] or OUT OFF [output no.]
you can also switch the outputs of your router on or off via SMS (ex-
ample: OUT ON 1, switches on Output 1 - OUT OFF 1, switches off
Output 1).
IN STATUS IN STATUS, this command responds by supplying the status of the
inputs.
GSM CMD With the command GSM CMD [at-command] it is possible to send
to the router modem any AT commands. The response of the mo-
dem is sent via SMS to the sender address (example: "GSM CMD
AT+cops?" responds by providing information about the network and
the provider).
Please note that only the first 160 characters of the modem response will be transferred.
Network - connection settings and options | Page 133 of 324