MB Connect Line mbNET.rokey RKH 210, Manual

Page: 180 / 324

Designation Description
Protocol The following protocols are available:
•
All - the set rule applies to all protocols.
•
Tcp - the set rule applies only to the TCP protocol.
•
Udp - the set rule applies only to the UDP protocol.
•
ICMP - the set rule applies only to the ICMP protocol.
Destination IP Enter the IP address to which data packets are to be sent initially.
Acceptable input: IP address or netmask or empty
Destination Port Enter the ports through which data packets are sent to the destination IP.
Acceptable input: Integer or List of ports (between 0 and 65535) separated with com-
mas or Port range [e.g. 32240-32245] or empty
Interface You can use this selection field to determine which interface the forwarding should nor-
mally be used. The options are:
•
Internet
•
WAN Ethernet
•
OpenVPN
•
IPSecVPN
•
PPTPVPN
•
LAN Ethernet
•
All
* The selection field for the interface can vary depending on the type of router.
forward to IP Enter the IP addresses to which data packets should actually be forwarded.
Acceptable input: IP address or netmask or empty
N O T I C E
If there is an active forwarding-rule, at least one IP address must always be to which the data traffic should
be forwarded.
forward to port Enter the ports through which the data packets will be forwarded.
Acceptable input: Integer or empty
N O T I C E
Ranges must be separated by a hyphen (-) and enumerated by comma (,).
No spaces between the elements to be separated!
Page 180 von 324 | V 7.2.0 - en | Aug 25 th , 2022 |