MTS600 Instruction Manual
57
measuring the second known point.
⑥
When the two known points have been input and
measured, the list of the known points is displayed.
l
Press [
▲
] [
▼
] to move the cursor up and down and select the known point.
l
Press [ADD] to add a known point for resection.
l
Press [REOBS] to reenter or re-observe the selected known point.
l
Press [CALC] to start resection calculation
l
Press [Y/N] to make the known point selected joining for calculation or not.
⑦
Press [CALC]. The instrument station coordinates
are calculated and displayed.
l
Press [REC] to store the results in the memory
l
Press [SET] to accept the calculated results as the
new station coordinates.
⑧
Press [SET] to set the instrument station
coordinates, then the direction angle of the last known
point as the backsight point is calculated and
displayed.
l
Pressing [SKIP] can leave out this step.
⑨
Collimate the last known point
，
press [SET] to set
the direction angle and finish setting up station, then
exit.
9.1.2 Calculating the station coordinate by measuring multiple known points
①
According to"9.1.1 Calculating the station
coordinate by measuring 2 known points"
，
input and
measure two known points, and then the list of the
known points is displayed
.
Resection
<*> Known pt1
<*> Known pt2
ADD REOBS Y/N CALC
N0 61874.215m
E0 54126.452m
Z0 70.000m
REC SET
Resection/Orientation
Direc.ang: 54
°
30
′
16
″
Collimate last kwn.pt?
SKIP SET
Program <1/2>
F1-Resection
F2-Offset-Measurement
F3-MLM
Resection
<*> Known pt1
<*> Known pt2
ADD REOBS Y/N CALC
