MTS600 Instruction Manual
56
9.1.1 Calculating the station coordinate by measuring 2 known points
①
In <Program> menu ,press [F1] to select
"Resection ".
Resection procedure will prompt "Input known pt1".
l
Press [PT#] to read in registered coordinate data
in memory by entering the point number of
known point. Please see"4.3 Coordinate measurement /Reading in registered
coordinate data"
l
Press [REC] to record input data into memory.
②
Input the coordinates of the first known point and
press [OK]. The procedure request inputting the prism
height of known point 1.
l
If only surveying plane coordinates of the station,
this step can be left out.
③
Measure and input the height of the prism, then
press [OK]. Procedure prompts for measuring known
point 1.
l
Press [MODE] to select distance measuring
mode.
l
Press [EDM] to check returned signal, set the atmosphere correction and the
prism constant, please see
“
4.2 distance measurement
”
④
Collimate the known point 1, press [MEAS] to
start measuring distance value and angle value of the
known point 1. After measurement is complete, the
results are displayed.
⑤
If the data was mistake, pressing [CE] may
observe the known point 1 again. Or press [OK] to
finish inputting and measuring the known point 1.
Then procedure will prompt
"
Input known pt2
"
.
Repeat the steps above to finish inputting and
N(m):
E(m):
Z(m)
：
PT#
REC
OK
Resection
Psm.ht(m)
：
0.000
OK
V.ang(Z) 88
°
40
′
42
″
H.ang(R) 45
°
23
′
07
″
Meas. Known pt1
MODE EDM CE MEAS
*H.dist 165.274m
*V.ang(Z) 91
°
55
′
37
″
*H.ang(R) 40
°
15
′
00
″
CE OK
N(m):
E(m):
Z(m)
：
PT# REC OK
