MTS600 Instruction Manual
9
②
Plug the charger into the wall outlet. then charging will start, the red lamp will
blink.
③
When charging finished ,the lamp light turns to green. Unplug the charger and
then remove the battery from the charger.
1.3.3 Charger operation manual
l
Never use this charger with other batteries.
l
This charger is a speedy set. it will finished the speed-charging in four
hours.
l
After speed-charging, the capability of the battery will attain 75%~80%. If
you want to charge it full, you need 2~4 hours small current charging.
l
When the charger is empty or in the small current charging, the green light
will bright. In the speediness status the red light will bright, when it finished, it
will turn into the small current status.
l
The battery will not be damaged in the small current status, but you had
better charge the battery not over twenty-four hours.
l
If there is much electricity remains in the batteries, the charger may not come
in the speediness status. It will charge it in the small current status. If you want
to charge it speediness, you must put the batteries in the charger and then
connect the charger with the power supply.
1.3.4 Mounting the battery
Insert the battery by aligning the battery guide with the guide hole in the
instrument. While pressing the release button of the battery downward , push the
battery toward the instrument until a click is heard.
1.3.5 Removing the battery
While pressing the release button of the battery downward ,remove the battery by
pulling it toward you.
1.3.6 Battery power display
There is a mark on the screen that can be used to check the status of the battery
power.
90-100% 50-90% 10-50% 0-10%
If there is no power, the instrument will give an alarm every ten seconds, and
display
“
Battery is low
”
. You should finish the measurement quickly, saving data
and changing another battery. Or not the power will be shut off after one minute.
