MTS600 Instruction Manual
41
⑤
Continue measuring next point.
l
Distance data include slope distance, vertical
angle, horizontal angle;
Coordinate data include N, E, Z coordinates;
Angle data include vertical angle, horizontal angle.
l
Press [ALL] to perform measurement and automatically record the results. In
this case, the point number is the last point number add one, the code and
prism height remain the same. When the measurement results recording
finished, the results will be displayed for two seconds, then the screen of last
step is restored.
6.5 Configuration of data recording
The below options can be set in data recording mode:
（
1
）
Sequence of measuring and recording
The sequence can be set as "measure first, then edit" , means that measure the
target point first, then input point number, code, prism height(this is default setting
by factory); or "edit first, then measure" , means that input point number, code,
prism height first, then measure the target point and record the data.
（
2
）
Automatic coordinate calculation
When this option is set, the instrument will
automatically calculate coordinate of target point and
store it to the JOB after measuring and recording
distance data. It
’
s very useful in traverse measurement.
（
3
）
Select distance measuring mode
Select a distance measuring mode special for data
recording mode
.
Example for setting
“
automatic coordinate calculate
”
option:
S.dist
V.ang(
Z
) 92
°
55
′
39
″
H.ang(
R
) 90
°
15
′
00
″
DIST
ANG
CRD
EDM
ALL
Recording Data/Config
F1-Recording sequence
F2-Auto coord.calc.
F3-Dist. Meas. mode
Auto coord.calc
⊙
F1--Off
○
F2--On
