Malaguti centro 160 ie, User Manual

Page: 140 / 242

2
3
4
6
1
5
42
ENG
5.16 BATTERY (12V - 9Ah)
The battery housing is in the central channel.
Fitting battery
(operation performed before delivery)
7R ÀW EDWWHU\ SURFHHG DV IROORZV
• Take a charged battery.
• Apply the adhesive band supplied with the vehicle
as shown in Fig.44 UHPRYLQJ WKH WZR SURWHFWLYH ÀOPV
from the ends of the adhesive area, as shown by the
arrow in the drawing ( P-Fig.44 ).
• Remove the 30A general protection fuse.
• Undo the 3 screws ( V-Fig.45 ) and remove the centre
partition under the seat ( S-Fig.45 ).
‡ 5HPRYH WKH EDWWHU\ À[LQJ FRYHU E\ UHPRYLQJ WKH
two screws ( C-Fig.46 ).
• Insert the battery and make sure it is correctly
seated.
‡ &RQQHFW WKH EDWWHU\ ZLULQJ
- positive pole (+) RED/BLUE cables
- negative pole (-) to the BLACK cables.
• Wrench down the battery terminals.
‡ 5HÀW WKH $ JHQHUDO SURWHFWLRQ IXVH SUHYLRXVO\
removed.
• Check that the battery and the wiring harness are
FRUUHFWO\ LQVWDOOHG \RX FDQ QRZ UHÀW WKH EDWWHU\
cover.
• Fit the partition.
NEVER invert the cable connections.
Do not use the vehicle if the battery has not been
ÀWWHG FRUUHFWO\ DQG FRQQHFWHG WR LWV FDEOHV
This may cause failures and short circuit of the
electrical system and its components.
,I WKH EDWWHU\ UHPDLQV ÁDW LW ZLOO EH VHULRXVO\
damaged.
We advise you to use protective gloves and
goggles while removing the battery from its
compartment, for example to recharge the
battery.