Magnetek Impulse G+ series 4, Technical Manual

Page: 153 / 248

IMPULSE•G+/VG+ Series 4 Technical Manual
November 2022
Page 153
Table 5-82: Selections for H03-02, H03-06, and H03-10 (Flux Vector)
Display Function
0 Analog Freq Ref1 Analog Frequency reference 1
10V = E01-04 (Maximum output frequency)
1 Frequency Gain Analog frequency reference will be multiplied with the analog frequency reference gain.
2 Analog Freq Ref2 Analog Frequency reference 2
10V = E01-04 (Maximum output frequency)
3 Analog Freq Ref3 Analog Frequency reference 3
10V = E01-04 (Maximum output frequency)
5 Acc/Dec T Reduct 10V = 100% acceleration and deceleration time
7 OT / UT Det Lvl Overtorque/undertorque level as a percentage of motor rated torque.
9 Ref Lower Limit Max. output frequency
10V = E01-04 (Maximum output frequency)
D Freq Ref Bias 2 The input value of an analog input set to this function will be added to the frequency reference.
This function can be used with any frequency reference source.
E MotorTemperature PTC thermistor input. Set DIP switch S4 to “PTC.”
10 FWD Torque Limit Torque limit when motoring in the forward direction.
11 REV Torque Limit Torque limit when motoring in the reverse direction.
12 Regen Torque Limit Torque limit during regen.
13 Torque Reference Torque reference when in Torque Control mode; Torque limit when in Speed Control mode.
14 Torque Comp Torque compensation when using torque control.
15 Torque Limit Torque limit when motoring.
16 Load Cell Used for Weight Measurement
1F Not Used -