C
HAPTER
4
| Configuring the Switch
Quality of Service
– 202 –
other than 00-00-00, then valid value of the PID will be any value
from 0x0000 to 0xffff.
■
IPv4
– IPv4 frame type includes the following settings:
■
Protocol
– IP protocol number. (Options: Any, UDP, TCP, or
Other (0-255))
■
Source IP
– Source IP address. (Options: Any, Specific)
To configure a specific source IP address, enter both the address
and mask format. The address and mask must be in the format
x.y.z.w where x, y, z, and w are decimal numbers between 0
and 255. When the mask is converted to a 32-bit binary string
and read from left to right, all bits following the first zero must
also be zero.
■
IP Fragment
– Indicates whether or not fragmented packets
are accepted. (Options: Any, Yes, No; Default: Any)
Datagrams may be fragmented to ensure they can pass through
a network device which uses a maximum transfer unit smaller
than the original packet’s size.
■
DSCP
– Diffserv Code Point value. (Options: Any, specific value
of 0-63, BE, CS1-CS7, EF or AF11-AF43, or Range;
Default: Any)
■
IPv6
– IPv6 frame type includes the following settings.
■
Protocol
– IP protocol number. (Options: Any, UDP, TCP, or
Other (0-255))
■
Source IP
– Source IP address. (Options: Any, Specific)
When configuring a specific IPv6 source address, enter the least
significant 32 bits (a.b.c.d) using the same type of mask as that
used for an IPv4 address.
■
DSCP
– Diffserv Code Point value. (Options: Any, specific value
of 0-63, BE, CS1-CS7, EF or AF11-AF43, or Range;
Default: Any)
■
Sport
– Source TCP/UDP port. (Any, Specific/Range: 0-65535)
■
Dport
– Destination TCP/UDP port. (Any,
Specific/Range: 0-65535)
Action Parameters
Indicates the classification action taken on ingress frame if the configured
parameters are matched in the frame's content. If a frame matches the
QCE, the following actions will be taken:
◆
Class
(Classified QoS Class) – If a frame matches the QCE, it will be
put in the queue corresponding to the specified QoS class, or placed in
Summary of Contents for GEP-5070
