LevelOne GEP-5070, User Manual

Page: 189 / 318

C
HAPTER
4
| Configuring the Switch
Quality of Service
– 189 –
verify conformity. Non-conforming traffic is dropped, conforming traffic is
forwarded without any changes.
P
ATH
Advanced Configuration, QoS, Port Policing
P
ARAMETERS
These parameters are displayed:
◆
Port – Port identifier.
◆
Enabled – Enables or disables port policing on a port.
◆
Rate – Controls the maximum rate for frames entering the ingress
queue for a port. (Range: 100-1,000,000 kbps/fps, 1-3.300 Mbps/kfps;
Default: 500 for all units of measure)
◆
Unit – Controls the unit of measure for the policer rate as kbps, Mbps,
fps or kfps. The default value is kbps.
◆
Flow Control – If flow control is enabled and the port is in flow control
mode, then pause frames are sent instead of discarding frames.
W
EB
I
NTERFACE
To configure ingress port policing:
1.
Click Advanced Configuration, QoS, Port Policing.
2.
Enable port policing as required for any port, set the maximum ingress
rate and unit of measure, and then enable flow control if required.
3.
Click Save.
Figure 76: Configuring Ingress Port Policing
C
ONFIGURING
E
GRESS
P
ORT
S
CHEDULER
Use the QoS Egress Port Schedulers page to show an overview of the QoS
Egress Port Schedulers, including the queue mode and weight. Click on any
of the entries in the Port field to configure egress queue mode, queue
shaper (rate and access to excess bandwidth), and port shaper.
P
ATH
Advanced Configuration, QoS, Port Scheduler