LevelOne GEP-5070, User Manual

Page: 120 / 318

C
HAPTER
4
| Configuring the Switch
Creating Trunk Groups
– 120 –
U
SAGE
G
UIDELINES
Besides balancing the load across each port in the trunk, the other ports
provide redundancy by taking over the load if a port in the trunk fails.
However, before making any physical connections between devices,
configure the trunk on the devices at both ends. When using a port trunk,
take note of the following points:
◆
Finish configuring port trunks before you connect the corresponding
network cables between switches to avoid creating a loop.
◆
You can create up to 9/13/25 trunks on a switch, with up to 18/26/50
ports per trunk (for the 18, 25 and 50-port models).
◆
The ports at both ends of a connection must be configured as trunk
ports.
◆
When configuring static trunks on switches of different types, they
must be compatible with the Cisco EtherChannel standard.
◆
The ports at both ends of a trunk must be configured in an identical
manner, including communication mode (i.e., speed, duplex mode and
flow control), VLAN assignments, and CoS settings.
◆
Any of the Gigabit ports on the front panel can be trunked together,
including ports of different media types.
◆
All the ports in a trunk have to be treated as a whole when moved
from/to, added or deleted from a VLAN.
◆
STP, VLAN, and IGMP settings can only be made for the entire trunk.
C
ONFIGURING
S
TATIC
T
RUNKS
Use the Aggregation Mode Configuration page to configure the aggregation
mode and members of each static trunk group.
P
ATH
Basic/Advanced Configuration, Aggregation, Static
U
SAGE
G
UIDELINES
◆
When configuring static trunks, you may not be able to link switches of
different types, depending on the manufacturer's implementation.
However, note that the static trunks on this switch are Cisco
EtherChannel compatible.
◆
To avoid creating a loop in the network, be sure you add a static trunk
via the configuration interface before connecting the ports, and also
disconnect the ports before removing a static trunk via the
configuration interface.
◆
When incoming data frames are forwarded through the switch to a
trunk, the switch must determine to which port link in the trunk an
outgoing frame should be sent. To maintain the frame sequence of
various traffic flows between devices in the network, the switch also