LevelOne GEP-5070, User Manual

Page: 226 / 318

C
HAPTER
5
| Monitoring the Switch
Displaying Information About Ports
– 226 –
◆
Conflict – Displays QCE status. It may happen that resources required
to add a QCE may not available, in that case it shows conflict status as
Yes, otherwise it is always shows No. Please note that conflict can be
resolved by releasing the resource required by the QCE and pressing
Refresh button.
W
EB
I
NTERFACE
To display the show the status of QCE entries
1.
Click Monitor, Ports, QCL Status.
2.
Select the user type to display from the drop-down list at the top of the
page.
3.
If any of the entries display a conflict, click Resolve Conflict to release
the resource required by a QCE. Then click Refresh to verify that the
conflict has been resolved.
Figure 104: QoS Control List Status
D
ISPLAYING
D
ETAILED
P
ORT
S
TATISTICS
Use the Detailed Port Statistics page to display detailed statistics on
network traffic. This information can be used to identify potential problems
with the switch (such as a faulty port or unusually heavy loading).
All values displayed have been accumulated since the last system reboot,
and are shown as counts per second. Statistics are refreshed every 60
seconds by default.
P
ATH
Monitor, Ports, Detailed Statistics
P
ARAMETERS
These parameters are displayed:
◆
Receive / Transmit Total
■
Packets – The number of received and transmitted packets (good
and bad).
■
Octets – The number of received and transmitted bytes (good and
bad), including Frame Check Sequence, but excluding framing bits.
■
Unicast – The number of received and transmitted unicast packets
(good and bad).
■
Multicast – The number of received and transmitted multicast
packets (good and bad).