Lenovo ThinkServer RD230, Software User'S Manual

Page: 234 / 364

6-26 MegaRAID Storage Manager Overview and Installation
6.6.1 Installing and Configuring an SNMP Agent on Linux
This section explains how to install and configure SAS SNMP Agent for
the SUSE Linux and Red Hat Linux operating systems.
To do this, perform the following steps.
Note: This procedure requires that you have Net-SNMP agent
installed on the Linux machine.
Note: The RPM has not been created to support -U version.
The RPM -U will probably fail with this RPM.
1. Install ThinkServer SAS SNMP Agent using
rpm -ivh
<sas rpm>
Note: After installation, find the SAS MIB file
ThinkServer-
AdapterSAS.mib
under the
/etc/ThinkServer_mrdsnmp/sas
directory.
RPM makes the necessary modification needed in the
snmpd.conf
file to run the agent.
Note: Before installation, check whether there is any pass
command that starts with 1.3.6.1.4.1.3582 OID in
snmpd.conf
. If so, delete all of the old pass commands that
if an earlier version of ThinkServer SNMP Agent was installed
The
snmpd.conf
file structure should be the same as
ThinkServer_mrdsnmpd.conf
. For reference, a sample conf file
(
ZThinkServer_mrdsnmpd.conf
2. To run an SNMP query from a remote machine, add the IP address
of that machine in the
snmpd.conf
file, as in this example:
com2sec snmpclient 172.28.136.112 public
Here, the IP address of the remote machine is
172.28.136.112
.
3. To receive an SNMP trap to a particular machine, add the IP address
of that machine in the
com2sec
section of the
snmpd.conf
file.
This section describes the installation and configuration of the
ThinkServer MegaRAID SNMP agent on Linux, Solaris, and
Windows operating systems.
if an earlier version of ThinkServer SNMP Agent was installed
in the system.)
) is in the /etc/ThinkServer_mrdsnmp directory.