Group 8
Job Editor
Page 115
JET3 Series
Release 2.02
Printstyle (5)
<Print height>
Default (80%)
<Orientation>
Default (0°)
<mirrored>
Default (no)
Print Parameter (6)
<PrintGo Distance>
150 mm
<PrintGo Repeat>
1
<endless>
Not selected
<PrintGo Source>
<Extern>
and
<positive edge>
.
<PrintStop interrupts print-
out immediately>
Default (no)
<PrintGo Gate>
Default (no)
Encoder Parameter (7)
<Encoder Source>
Extern
<Resolution>
12.500
<intern Speed>
Not available if an external encoder is used
<Encoder/Direction>
Clockwise
<Speed dependent output>
Not used. Default (700)
<lock backward>
yes
Date Change Parameter (8)
<Date Change Offset>
Default
(0)
7. Save the created job list
(9-10)
.
8. Open the job list with the
<Load Joblist to print>
command
(11-12)
.
9. Get the printer ready to print (open nozzle seal, push green
<PrintStart>
button).
10. The
<PrintGo>
signal sets the reference point for all distances assigned to the
print jobs on the job list. The first print job of the job list will be printed in a distance
of 30 mm to that reference point
(13)
.
11. The second print job of the job list will be printed in a distance of 70 mm to the
reference point
(13)
.
12. The third print job of the job list will be printed in a distance of 110 mm to the
reference point.
(13)
.
13. In the
<PrintGo Parameters>
of the
<Joblist Settings>
parameter for
<PrintGo
distance>
and
<PrintGo repetition>
were set. The
<PrintGo distance>
was set
to 150 mm and there shall be one repetition. Therefore all three jobs on job list
will be printed again in the same matter as described in points 9-11. The repetition
will start 150 mm from the reference point
(13)
.
14. The task is finished.
Summary of Contents for JET3
Page 1: ...Operating Manual V2 02 Please keep for future reference ...
Page 2: ......
