Kyocera 1102RX3NL0, Operation Manual

Page: 48 / 242

2-17
Installing and Setting up the Machine > Network Setup
Network Setup
Configuring the Wired Network
The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP (IPv4),
TCP/IP (IPv6), NetBEUI, and IPSec. It enables network printing on the Windows, Macintosh, UNIX and other platforms.
Set up TCP/IP (IPv4) to connect to the Windows network.
Be sure to connect the network cable before configuring the settings.
Connecting LAN Cable (page 2-7)
For other network settings, refer to the following:
Network Settings (page 6-13)
IPv4 setting
1
Display the screen.
[ Menu ] key > [ ▲ ] [

] key > [ Wired Network ] > [ ► ] key > [ ▲ ] [

] key > [ TCP/IP ] > [ OK ] key
2
Configure the settings.
1
[ ▲ ] [

] key > [ On ] > [ OK ] key
2
Select [ ► ] key while "TCP/IP On" is displayed.
3
[ ▲ ] [

] key > [ DHCP ] > [ OK ] key > [ ▲ ] [

] key > [ Off ] > [ OK ] key
4
[ ▲ ] [ ▼ ] key > [ IP Address ] > [ OK ] key
5
Set the IP address.
6
Select the [ OK ] key.
7
[ ▲ ] [ ▼ ] key > [ Subnet Mask ] > [ OK ] key
8
Set the subnet mask.
9
Select the [ OK ] key.
10
[ ▲ ] [ ▼ ] key > [ Default Gateway ] > [ OK ] key
NOTE
You can set any value between 000 and 255.
Select the [
▲ ] or [ ▼ ] key to enter a number.
Select the [ ◄ ] or [ ► ] key to move the cursor left or right.
NOTE
You can set any value between 000 and 255.
Select the [
▲ ] or [ ▼ ] key to enter a number.
Select the [ ◄ ] or [ ► ] key to move the cursor left or right.