Kwik Lok 893A ULTRA, Instruction Manual

Page: 61 / 106

893 05 15
IMPORTANT: When ordering parts ALWAYS:
(1) Specify on the order the TYPE , MODEL and SERIAL NUMBER of the machine for which the parts
are being ordered. This information is found on the machine nameplate (serial number).
(2) Do NOT order by item number. Order by part number.
To order individual PARTS, be sure to observe the following:
A. Refer to the appropriate assembly illustration (Figures 8.1 - 8.23).
Each PART is assigned an "Item Number" on the illustration.
DO NOT ORDER BY ITEM NUMBER.
B. Refer to the corresponding Parts List. Locate the Item Number in the left-hand column.
Opposite the Item Number is the Part Number and Description to be listed on the parts order.
C. Specify on the order the Type, Model and Serial Number of the machine for which PART(S) are
being ordered. This information will be found on the machine nameplate (serial number).
As an example - to order a Bag Sensor Lever - Figure 8.3 (Page 8.5) identifies the Bag Sensor Lever as
item 3. Refer to the appropriate Parts List. The description for Item Number 3 is "Part No. 08-006021,
Lever - Bag Sensor." If the machine nameplate is marked "Type 893AAJ-NRPR, Serial No. 10001-2008,"
the order should specify as follows:
"One Part Number 08-006021, Lever - Bag Sensor "
(For Closing Head Type 893AA J-NRPR, Serial No. 10001-2011)
PARTS ORDERING PROCEDURES
The closer is a RIGHT or LEFT- HAND model (Details Page
8.2).
Parts lists include part numbers for both Right and Left-Hand
models when applicable. Part numbers followed by an R are specif-
ic to a Right-Hand closer. Numbers followed by an L are specific to
a Left-Hand closer.
SECTION VIII
Parts Identification
P 8.1