Kubota M7131, Operator'S Manual

Page: 174 / 298

PTO 142
A
For maximum PTO shaft speeds of various
implements, see the implement Operator's Manual.
B
1000 rpm PTO Shaft
(if equipped)
To avoid personal injury or death:
A
Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
For replacement with a 21-spline 1000-rpm PTO shaft,
follow the procedure below.
C
PTO shaft interchanging procedure
1. The 6-spline 540 rpm PTO shaft is standard
equipment.
2. Shifting the two PTO levers to an arbitrary position,
lock the PTO shaft to keep it from rotating.
3. Remove the PTO mounting bolts and then remove the
PTO shaft.
4. After cleaning the PTO shaft mounting surface, mount
the 1000-rpm PTO shaft.
Tightening torque: 115 N-m (11.7 kgf-m)
A
For maximum PTO shaft speeds of various
implements, see the implement Operator's Manual.
A Implements may be driven at 540 rpm only if their
power input never exceeds 60 kW (82 HP).
B
PTO Shaft Cover and Shaft Cap
Keep the PTO shaft cover in place at all times. Replace
the PTO shaft cap when the PTO is not in use. Before
connecting or disconnecting a drive shaft to PTO shaft, be
sure engine is "OFF".
A The universal joint of the PTO drive shaft is technically
limited in its moving angle. Refer to the PTO Drive
Shaft Instructions for proper use.
(1) PTO gear shift lever
(2) PTO operating mode selector lever (A) Normal mode
(B) Economy mode
(C) 540/540E rpm
(D) 1000/1000E rpm
(N) Neutral position
(1) PTO shaft
(2) Bolt (A) 540 rpm PTO shaft
(B) 1000 rpm PTO shaft
(1) PTO shaft cover
(2) PTO shaft cap