Kubota M7131, Operator'S Manual

Page: 106 / 298

PRE-OPERATION CHECK 74
3. The 10 maintenance items are displayed on the LCD
unit.
The hours shown at the far right of each item indicate
the duration of use after the immediately previous
maintenance.
Every time the "Select" switch is pressed, the "
● " circle
moves down and the next items appear one by one.
Highlighted hours mean that the inspection interval or
replacement interval has been reached. Immediately
inspect the relevant part or replace it with a new one.
B
Resetting Procedure
When an inspection or replacement has been made, reset
the hours of the maintenance item.
1. Using the "Select" switch, move the "
● " circle to the
relevant maintenance item.
2. Press the "ENT" switch, and the reset screen shown
below appears. Using the "Select" switch, choose
"YES". Then press the "ENT" switch, and the
displayed hours will be back to zero.
(1) SET UP/00 switch
(2) Select switch
(3) ENT switch
(1) Setting mode screen
(2) Service inspect indicator
(1) Engine oil filter
(2) Fuel filter
(3) Hydraulic suction oil filter
(3-point hitch)
(4) Transmission filter
(5) Transmission fluid (6) Rear axle case oil
(7) Front axle case oil
(8) Wheel bolt torque
(9) Engine oil separator element
(10) Engine oil