Kubota M7131, Operator'S Manual

Page: 76 / 298

INTELLIPANEL(TM) CONTROL 44
B Setting the 3-Point Hitch
On the menu shown below, the 3-point hitch height and lowering speed, draft/position control, and ride control can be
preset.
With the optional radar device in place, the slip control is also enabled.
C Switching between 3-point hitch lock and unlock
Touch the left half of the 3-point hitch lock switch (6), and
the 3-point hitch gets locked. A touch on the right half
unlocks the 3-point hitch.
While it is locked, the indicator (1) lights up and stays on.
C Adjusting the lift arm top limit control (17)
Touch the "Plus (+)" switch (10) or the "Minus (-)" switch
(11) on the right side of the lift arm top limit control (17) to
readjust the top limit height.
Raise the percentage to increase the top limit.
When it has reached 100%, the top limit setting is
cancelled.
C
Adjusting the lift arm bottom limit control (15)
Using the depth control dial (hydraulic dial), the bottom
limit height can be readjusted.
Lower the percentage to decrease the bottom limit.
When the auto draft mode switch (8) is ON, the lower link
lowering position varies according to the draft sensitivity
control (13) setting value.
C Displaying the lift arm height (16)
The current lift arm position (height) is automatically
displayed with the bar graph and percentage.
A higher percentage shows a higher 3-point hitch height.
C Adjusting the 3-point hitch lowering speed control
(14)
Extend the graph farther to the right (raise the percentage)
to increase the lowering speed.
C
Switching the automatic draft control
Touch the left half of the auto draft mode switch (8), and
the automatic draft control gets activated. A touch on the
right half deactivates it.
If a "lowering" action is made with the depth control dial
(hydraulic dial) or the 3-P. quick lower switch in the
automatic draft control mode, the indicator (4) lights up
and stays on.
C
Adjusting the draft sensitivity control (13)
Extend the graph farther to the right (raise the percentage)
to increase the draft sensitivity. Depending on the type of
job, readjust the draft sensitivity.
If the draft sensitivity is set at 0%, the position control
works instead.
(1) 3-point hitch lock indicator
(2) 3-point hitch status indicator
(3) Ride control indicator
(4) Auto draft mode indicator
(5) Wheel slip control indicator
(6) 3-point hitch lock switch
(7) Ride control switch
(8) Auto draft mode switch
(9) Wheel slip control switch
(10) Plus (+) switch
(11) Minus (-) switch
(12) Wheel slip control
(13) Draft sensitivity control
(14) 3-point hitch lowering speed control
(15) Lift arm bottom limit control
(16) Lift arm height control,
current position (height)
(17) Lift arm top limit control