3-S38
L4400 , WSM
TRANSMISSION
(3) Check and Adjustment of Range Gear Shift Lever
CAUTION
• Park the tractor on a firm and level ground and set the parking brake.
• Lower the loader and other implement to the ground.
• Stop the engine, and remove the key.
When shifting slowly the range gear shift lever from the position H (High) to the position N (Neutral), the gear inside
sometimes remains at the position H and does not move, although the range gear shift lever is at the position N.
It has been caused by a bad adjustment of the turnbuckle.
Please verify and adjust the turnbuckle as follows.
Points to be checked
1. Shift the range gear shift level to N (Neutral) position on the H
(High) speed side. Keeping the lever slightly being pushed
forward (to the left of the photo), measure the overlapping length
(A) of the level and guide.
2. Judgement
[1] CORRECT : Length (A) is 1 to 5 mm (0.04 to 0.2 in.) when the
guide and lever are overlapping.
[2] INCORRECT : The overlapping length (A) is less than 1 mm
(0.04 in.), or when there is a clearance between the guide and
lever. In this case, carry out the following adjustment.
W10781900
A : Overlapping length of the level
and guide.
P : The free play stroke of range
lever.
a : The forward position of range
lever in neutral position.
b : The backward position of range
lever in neutral position.
c : The end of the guide.
KiSC issued 07, 2007 A
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland