G-15
L4400 , WSM
G GENERAL
Replacing Hydraulic Oil Filter
CAUTION
• Be sure to stop the engine before changing the oil filter.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Place an oil pan under the tractor.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid.
4. After draining, screw in the drain plugs.
5. Remove the oil filter cartridge (4) by using a filter wrench.
6. Make sure the mounting surface is clean.
Put a film of clean transmission fluid on the rubber seal of the new
filter.
7. Install the new filter cartridge.
8. Quickly tighten the filter until it contacts the mounting surface,
then tighten it by hand an additional 1/2 turn only.
9. After the new filters have been replaced, fill oil up to the upper line
on the gauge (2).
10.After running the engine for a few minutes, stop it and recheck
the oil level, add oil to the prescribed level.
11.Make sure that the transmission fluid doesn’t leak through the
seal of the filter.
IMPORTANT
■
• To prevent serious damage to the hydraulic system. Use
only a genuine KUBOTA filter or its equivalents.
W1058427
Changing Front Axle Case Oil [4WD]
1. Place the oil pans underneath the front axle case.
2. Remove the drain plug (1) both sides and filling port plug (3) to
drain the oil.
3. After draining, reinstall the drain plug.
4. Remove the oil level check plug (2).
5. Fill with the new oil up to the check plug (2) port.
6. After filling, reinstall the check plug (2) and filling port plug.
IMPORTANT
■
• Use KUBOTA SUPER UDT fluid or SAE 80, 90 gear oil. Refer
to “LUBRICANTS, FUEL AND COOLANT”. (See page G-8.)
W1059460
(1) Drain Plug
(2) Gauge
(3) Filling Plug
(4) Hydraulic Oil Filter
A : Oil level is acceptable within this
range.
Front axle case oil
Capacity
6.5 L
6.9 U.S.qts
5.7 lmp.qts
(1) Drain Plug
(2) Check Plug
(3) Filling Port Plug
KiSC issued 07, 2007 A
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
