1-S27
L4400 , WSM
ENGINE
Separating Engine from Clutch Housing
1. Place the disassembling stand under the engine and clutch
housing case.
2. Remove the steering support plates connecting steering support
and rear bonnet support.
3. Remove the engine and clutch housing mounting screws and
nuts.
4. Separate the engine and clutch housing.
(When reassembling)
• Apply grease to the spline of clutch shaft.
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the flywheel housing and clutch housing.
W1044021
Clutch Assembly
1. Insert the clutch center tool.
2. Remove the clutch assembly together with the clutch center tool.
(When reassembling)
• Direct the shorter end of the clutch disc boss toward the flywheel.
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of clutch disc boss.
• Insert the pressure plate, noting the position of straight pins.
IMPORTANT
■
• Be sure to align the center of disc and flywheel by inserting
the clutch tool set.
NOTE
■
• Do not allow grease and oil the clutch disc facing.
W1044164
Tightening torque
Engine and clutch housing
mounting screw and nut
M12, grade 7
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
Engine and clutch housing
mounting stud bolt
39.2 to 49.0 N·m
4.0 to 5.0 kgf·m
28.9 to 36.2 ft-lbs
Tightening torque
Clutch mounting screws
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
(1) Clutch Disc
(2) Pressure Plate Assembly
KiSC issued 07, 2007 A
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
