Korg M3, Parameter Manual

Page: 151 / 647

COMBI P1: DT/XY/Ctrls 1–2: X–Y Vol T01–08, 1–3: X–Y Vol T09–16
141
When Equal Amount is Off, the individual Timbre Center
Volume
parameters determine the way in which X–Y
position affects volume.
Note: For an interesting variation on this effect, turn Equal
Amount
Off, and instead set all of the Timbre Center
Volumes to 50%. The Timbres will still fade together
smoothly, but with a more gentle effect towards the
extremes of the X–Y axes.
1–2(3)b: X–Y Graphic
X–Y Graphic
The X–Y graphic is shown if Equal Amount is on, or to
indicate the way in which volume is changed by the Center
Volume setting.
Timbre Select [01…16]
This selects the timbre whose data will be shown in the X–Y
graph.
1–2(3)c: Timbre Info
Selected Timbre Info:
This area displays information about the timbre selected for
editing – T: timbre number/program bank/number/name,
Ch:
MIDI channel number.
Timbre Number:
This indicates the timbre number. The various parameters
below each timbre number make settings for the
corresponding timbre.
Timbre Category:
This shows the abbreviated category name of the Program
assigned to the Timbre.
1–2(3)d: X–Y Assign, Center Volume,
Enable Program X–Y Volume
Timbre 1
X–Y Assign [Off, +X, –X, +Y, –Y]
This assigns an axis of the X–Y to control the Timbre’s
volume. See the diagram “X–Y Assign and Program
Volume,” below, for more details.
Off means that the X–Y position will not affect the Timbre’s
volume.
X–Y Assign and Program Volume
Center Volume [0, 25, 50, 75, 100%]
This sets the volume of Timbre 1 at the center point. It
applies only when Equal Amount, above, is set to Off.
The volumes at the extreme ends of the axis are fixed,
depending on the setting of the X–Y Assign parameter.
For instance, if X–Y Assign is set to –X, the Timbre will
always be at 100% volume on the left side, and 0% (silent) on
the right side.
This parameter applies only to the Combi X–Y Volume
control, and does not change the Program’s individual X–Y
Volume settings.
Timbre Center Volume, X–Y Assign = –X
Enable Program X–Y Volume [Off, On]
When this is turned On, the Program’s X–Y Volume control
will function as it does in Program mode, crossfading
between Oscillators 1 and 2. The program’s X–Y volume
setting is controlled by the X–Y position.
When this is turned Off, the Program’s X–Y Volume control
will be disabled.
Select Timbre Info
Timbre Number
Timbre Category
+127 –127 0
0% 100%
+127 –127 0
100% 0%
+127
–127
0
0%
100%
+127
–127
0
100%
0%
+X –X
Program volume increases
from left to right. Program volume increases
from right to left.
+Y –Y
Program volume increases
from bottom to top. Program volume increases
from top to bottom.
50%
100%
0%
–127 0 +127
100
75
50
25
0
Volume
Vector X-axis position
Center Volume Values: