Kongsberg Seatex Seapath 200, Installation Manual

Page: 38 / 130

Seatex Seapath 200 Installation Manual, rev. 13 Installation
24
Synchronised with this signal it is possible to output 1PPS time tag messages from Seapath.
These messages are the 1PPS NMEA ZDA (format no. 13) or the Trimble compatible
message (format no. 14). For description of the format for these messages see "Appendix B -
Output Protocols From Seapath".
3.4.2.5 Analog output
Three analog output channels are available from the AUX – Serial port at the rear of the
Processing Unit. The variables available for analog output are roll, pitch, heave and Datawell
Hippy compatible roll and pitch signals. The selection of variable and channel properties is
performed in the SCC configuration software, see chapter 8.4.5.4 for details.
The pin wiring for the analog output part of the AUX – Serial port is as follows:
AUX – Serial port
Pin no. Signal Description
24 AGND Common ground for all analog signals
12 +AOUT-1 Analog output signal for channel no. 1
25 +AOUT-2 Analog output signal for channel no. 2
13 +AOUT-3 Analog output signal for channel no. 3
Note
The other pins on the AUX - Serial port must not to be connected to anything.
They have to be open.
Optionally, a DB-25 connector for the AUX - Serial port with the analog output signal
connected can be delivered. This cable has a 3-metre cable length with the DB-25 connector
in one end and is open in the other. The cable part number is M320-42 and a wiring drawing
is shown in chapter 4.