Kongsberg Seatex Seapath 200, Installation Manual

Page: 114 / 130

Seatex Seapath 200 Installation Manual, rev. 13 Appendix D – Seapath configuration software, SCC
100
Figure 55 Common Host Settings
8.4.5.2 Network common
In order to output Seapath data on the Ethernet connector as an UDP (User Datagram
Protocol) diagram the following parameters have to be set:
•
The Internet protocol (IP) network address. Default is 192.168.1.10.
•
The Internet protocol (IP) network mask. Default is 255. 255. 255. 0.
•
The NMEA ID. A two-letter talker identifier in NMEA messages as defined in [1].
Default is IN (Integrated Navigation).
•
A token number
.
Numerical token in binary messages. The token number is selected in the
area 0 to 255.
Proceed as follows to set the common network parameters:
•
In the Configuration Folder List, select
Data Interface \ Network Common.
•
In the
IP Network Address
field, enter the port ID.
•
In the
IP Network Mask
field, input the mask.
•
In the
FTP Server Password
, input wanted password to gain access to the FTP server.
The default password is "seapath". This password is typically needed when transferring
Seapath log files through the Ethernet to an external PC. Then the Seapath will ask for this
password.
•
In the
NMEA Identification
field, enter a two-character identification text.
•
In the
Binary message token
field, enter a token number to be output in the Seapath
binary formats.
Note
Changes in the
IP Network Address
or
Mask
will only take effect after a restart
of the Seapath system.