Kongsberg Seatex Seapath 200, Installation Manual

Page: 115 / 130

Seatex Seapath 200 Installation Manual, rev. 13 Appendix D – Seapath configuration software, SCC
101
Figure 56 Common Network Settings
Check with the network administrator on board the vessel for the correct selection of network
address and mask.
8.4.5.3 Input
In this folder list, all the input interface to the Seapath unit is selected. The following four
devices can be input to the unit:
•
The GPS antenna signals and the MRU communication. The settings for the interface with
these devices are fixed in the system and cannot be changed by the user.
•
External gyro input. Seapath can use heading data from an external source, for example a
gyro compass, as backup to improve reliability. The properties and format of this signal
are to be set by the user.
•
Differential GPS corrections. DGPS corrections from up to four different data links can be
input to Seapath. The properties and format for each of these links have to be set by the
user.
•
The SCC configuration port. The properties of the operational communication port
(OpCom) for connecting an external PC for configuration of the Seapath unit with SCC
can be set by the user. Default is com1 and normally this configuration shall not be
changed.
Figure 57 Data Interface - Input Configuration