Kongsberg Seatex Seapath 200, Installation Manual

Page: 113 / 130

Seatex Seapath 200 Installation Manual, rev. 13 Appendix D – Seapath configuration software, SCC
99
Figure 54 Measurement Points Geometry
Note
If data shall be valid for centre of gravity, it is not necessary to define a zero
vector since the data is default output in CG.
8.4.5 Data interface
8.4.5.1 Host common
For identification of the output protocols from Seapath on the serial lines, the following
parameters can be set:
•
NMEA ID
. A two-letter talker identifier in NMEA messages as defined in [1]. Default is
IN (Integrated Navigation).
•
Token
. Numerical token in binary messages. The token number is selected in the range 0
to 255.
Proceed as follows to set the common host parameters:
•
In the Configuration Folder List, select
Data Interface \ Host Common.
•
In the
NMEA Identification
field, enter a two-character identification text.
•
In the
Binary message token
field, enter a token number to be output in the Seapath
binary formats.