Kongsberg Seatex Seapath 200, Installation Manual

Page: 118 / 130

Seatex Seapath 200 Installation Manual, rev. 13 Appendix D – Seapath configuration software, SCC
104
Figure 62 Data Interface - Output Configuration
In order to set up the different output devices, proceed as follows:
•
In the Configuration Folder List, select
Data Interface \ Output.
•
Activate the device to be interfaced by clicking on the checkbox in front of the device
name.
•
The property of the selected Device are set by clicking in the wanted
Properties
cell
belonging to the "Host Out" device, and the box shown in Figure 58 appears. Select the
wanted settings and click
OK
. Click in the wanted
Properties
cell belonging to the
"Network Out" device, and the
Network Settings
dialogue box below appears. Select the
wanted Port Number and click
OK
. The default port number is recommended used unless
it is in conflict with other equipment connected to the network.
Figure 63 Network Settings
•
Click in the wanted
Properties
cell belonging to the "Analog Out" device, and the
Analog Settings
dialogue box below appears. Enter the wanted settings and click
OK
.