Kongsberg Seatex Seapath 200, Installation Manual

Page: 40 / 130

Seatex Seapath 200 Installation Manual, rev. 13 Installation
26
|-----------------------------User side x1-----------------------------|
pin signal description pin signal description
1 PWRIN+ power + 23 XIN to MRU
2 PWRIN- power gnd 24 LGND gnd ref.aux.+dig
3 TX+ from MRU 27 SHUTOFF of MRU
4 TX- -"-
5 RX+ to MRU
6 RX- -"-
3.
Connect the cables for output data from Seapath to external equipment to the ports com5,
6, 7 or com8 for RS-232 or 422 communication (RS-232 is the default setting), analog
output signals on the AUX – Serial port or the Ethernet connection. If additional serial
ports are required the ports com13to com16 available on the "AUX - Serial" port can be
used, see chapter 3.4.3.3 for instructions.
4.
Connect the 110/230V AC ship's power supply to the Seapath power connector at the rear
of the Processing Unit.
5.
Connect the cable from the Video Display Unit and the keyboard to the corresponding
connectors at the rear of the Processing Unit.
6.
Connect the Video Display Unit to 110/230V AC ship's power.
7.
If available, connect the cables with the DGPS corrections to port com10 and the external
gyro compass signal to com9 at the rear of the Processing Unit. Optionally, additional
DGPS correction signals can be connected to the free communication ports in the range 5
to 9 instead of output lines and gyro input.
8.
When all cables are connected, power on the Processing Unit. The four LED indicators
located behind the door on the front panel of the Processing Unit should then start to shine
red. The LED1 light diode in the MRU junction box should then shine green indicating
that the MRU receives power. A yellow light in LED2 indicates that digital data are sent
from the MRU on TX+.
9.
If the lights in the LED1 and 2 in the MRU junction box are shining, the installation is
now completed and you can continue to set up the configuration parameters.