Kohler Comand Pro CH1000, Service Manual

Page: 118 / 142

10.8
Section 10
Reassembly
4. Ensure the end of the tabbed washer on the
governor gear is positioned outward in the
6 o’clock position inside the crankcase. See Figure
10-28.
Figure 10-28. Tabbed Washer Details.
5. Orient the fl at of the oil pump gear to match the
position of the fl at on the camsha ft . Then install
the closure plate to the crankcase. Carefully
seat the camsha
ft and the cranksha ft into their
mating bearings. Rotate the cranksha ft slightly to
help the oil pump and governor gears mesh. See
Figure 10-29.
Figure 10-29. Installing Closure Plate.
6. Install the fourteen hex fl ange screws securing
the closure plate to the crankcase. Torque the
fasteners in the sequence shown in Figure 10-31
to
24.4 N·m (216 in. lb.) .
Figure 10-30. Torquing Closure Plate Screws.
10
8
1
14
3
5
12
7
9
11 6
4
2
13
Figure 10-31. Closure Plate Fastener Torque
Sequence.
Install Oil Pickup Screen
1. Apply a small amount of oil to the grommet of
the pickup screen and insert it onto the lower end
of pickup tube within the crankcase. Secure the
pickup to the boss on the bo
tt om of crankcase.
Torque the mounting screw to 10.7 N·m
(95 in. lb.) into a new hole, or 7.3 N·m (65 in. lb.)
into a used hole. See Figures 10-32 and 10-33.
Pickup Screen Pickup Screen
Pickup Tube Pickup Tube
Figure 10-32. Installing Pickup Screen.