Kohler Comand Pro CH1000, Service Manual

Page: 126 / 142

10.16
Section 10
Reassembly
2. Mount the intake manifold to the cylinder heads.
Make sure the gaskets remain in the proper
position. Torque the four screws in two stages,
fi rst to 16.9 N·m (150 in. lb.) , fi nally to 22.6 N·m
(200 in. lb. ) , using the sequence shown in Figure
10-63.
Figure 10-62. Installing Intake Manifold.
3
1
2
4
Figure 10-63. Intake Manifold Torque Sequence.
3. Install the carburetor mounting studs into the
intake manifold if previously removed. Use two
hex nuts, locked
fl ange to fl ange, and tighten
each of the studs until bo tt omed/tight.
Install Oil Filter Housing Assembly
Reassemble the oil fi lter housing if disassembled
previously.
Reassembly
1. Install the small spring onto the rubber valve, and
insert the small end through the corresponding
hole in cup until properly seated. See Figure
10-64.
Cup
Valve
Spring
Figure 10-64. Installing Valve and Spring to Cup.
2. Install the larger spring into the fi lter housing.
See Figure 10-65.
Spring
Figure 10-65. Installing Spring into Housing.
3. Insert the oil fi lter cup, aligning the cutout with
the corresponding section in the housing. See
Figure 10-66.
Cup
Figure 10-66. Installing Cup.