Kohler Comand Pro CH1000, Service Manual

Page: 127 / 142

10.17
Section 10
Reassembly
10
4. Install the nipple in housing and torque to
18.0 N·m (159 in. lb.) . See Figures 10-67 and
10-68.
Nipple
Figure 10-67. Installing Nipple.
Figure 10-68. Torquing Nipple.
Installation
1. Make sure all sealing surfaces are clean and all
three dowel pins are in position. Install or check
that new O-rings are around all three dowel pins
of the oil
fi lter adapter. See Figure 10-69.
O-rings O-rings
Figure 10-69. O-rings Installed on Adapter for Oil
Filter Housing.
2. Install the oil fi lter housing assembly to the
adapter and secure with the M8 hex head screw.
Make sure the housing is
fl at on the crankcase
and all O-rings remain in position. Torque the
screw to
24.4 N·m (216 in. lb.) .
Oil Filter Housing
Mounting
Screw
Figure 10-70. Installing Oil Filter Housing.
3. The oil fi lter may be installed now or upon
completion of engine assembly, as described in
Section 6.
Install Backing Shroud Assembly
1. To aid assembly, install the lower oil cooler hose
onto the oil fi lter housing prior to installation of
the backing shroud assembly, and secure with a
clamp. See Figure 10-71.
Figure 10-71. Lower Oil Cooler Hose Details.
NOTE: New hose clamps are recommended for
reassembly, or if clamps have been loosened
(expanded) several times to avoid leakage.