Kohler Comand Pro CH1000, Service Manual

Page: 138 / 142

10.28
Section 10
Reassembly
Install Muffl er
1. Install new exhaust gaskets onto the exhaust
studs.
2. Install the port liners (if equipped). A tt ach the
mu ffl er and secure with the four hex fl ange nuts
onto the exhaust studs. See Figure 10-110. Torque
the hex
fl ange nuts to 24.4 N·m (216 in. lb.) .
Flange Nuts (4)
Figure 10-110. Installed Muffl er.
3. Install any a tt aching hardware and brackets.
Torque M6 screws to 9.9 N·m (88 in. lb.), and M8
screws to 24.4 N·m (216 in. lb.) .
4. Install spark arrestor (if used).
Install Oil Filter and Add Oil to Crankcase
1. Install the oil drain plugs. See Figure 10-111.
Torque the plugs to 21.4 N·m (16 ft . lb.) .
NOTE: Make sure that both oil drain plugs
are installed and torqued to the above
speci
fi cations to prevent oil leakage.
Oil Drain Plug Location (Starter Side Shown)
Figure 10-111. Reinstall Oil Drain Plugs.
2. Install a new oil fi lter following the instructions
in Section 6.
3. Apply a thin fi lm of clean engine oil to the rubber
gasket on the oil fi lter and thread the fi lter onto
the adapter nipple. See Figure 10-112.
4. Install the new oil fi lter to the fi lter adapter or oil
cooler. Refer to instructions on the oil fi lter for
proper installation. See Figure 10-112.
Figure 10-112. Installing Oil Filter.
5. Add oil to bring the level up to the F mark.
Reinstall the dipstick and oil fi ll cap. See Figure
10-113.
Figure 10-113. Reinstall the Dipstick.
Connect Spark Plug Leads
1. Connect the leads to the spark plugs. See Figure
10-114.