Keysight E3631A Service Guide
13
Front-Panel Voltage and Current Settings
You can set the voltage and current from the front panel using the following
method.
Use the voltage/current adjust selection key, the resolution selection keys, and
the control knob to change the limiting or limitings value of voltage or current.
1
Press the “Display Limit” key after turning on the power supply.
2
Set the knob to the voltage control mode or current control mode using the
voltage/current adjust selection key.
3
Move the blinking digit to he appropriate position using the resolution
selection key.
4
Change the blinking digit to the desired value using the control knob.
5
Press the “Output On/Off” key to enable the output. After about 5 seconds, the
display will go to the output monitor mode automatically to display the
voltage and current at the output.
NOTE
All front panel keys and controls can be disabled with remote interface
commands. The Keysight E3631A must be in "Local" mode for the front panel
keys and controls to function.
Summary of Contents for E3631A
