Keysight Technologies InfiniiVision 3000T X Series, Programmer'S Manual

Page: 1036 / 1420

1036 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
33
:TRIGger Commands
:TRIGger[:EDGE]:SOURce
(see page 1276 )
Command Syntax
:TRIGger[:EDGE]:SOURce <source>
<source> ::= {CHANnel<n> | EXTernal | LINE | WGEN | WGEN1
| WMOD} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d> | EXTernal | LINE | WGEN | WGEN1
| WMOD} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
Note: WAVE and WGEN1 are equivalent.
The :TRIGger[:EDGE]:SOURce command selects the input that produces the
trigger.
• EXTernal — triggers on the rear panel EXT TRIG IN signal.
• LINE — triggers at the 50% level of the rising or falling edge of the AC power
source signal.
• WGEN, WGEN1 — triggers at the 50% level of the rising edge of the waveform
generator output signal. This option is not available when the DC, NOISe, or
CARDiac waveforms are selected.
• WMOD — when waveform generator FSK or FM modulation is used, triggers at
the 50% level of the rising edge of the modulating signal.
Query Syntax
:TRIGger[:EDGE]:SOURce?
The :TRIGger[:EDGE]:SOURce? query returns the current source. If all channels are
off, the query returns "NONE."
Return Format
<source><NL>
<source> ::= {CHAN<n> | EXT | LINE | WGEN | WGEN1 | WMOD
| NONE} for the DSO models
<source> ::= {CHAN<n> | DIG<d> | EXTernal | LINE | WGEN | WGEN1
| WMOD | NONE} for the MSO models
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":TRIGger:MODE" on page 1016
Example Code
' TRIGGER_EDGE_SOURCE - Selects the channel that actually produces th
e
' edge trigger. Any channel can be selected.
myScope.WriteString ":TRIGger:EDGE:SOURce CHANnel1"
See complete example programs at: Chapter 42 , “Programming Examples,”
starting on page 1285