Configuring Mobile Relay Station
Preparation in advance
The configuration conditions of the
Mobile Relay Station
function are as follows:
Firmware version of the transceiver:
Firmware version 2.00.00 or later
FPU:
KPG-D1/ D1N V2.00 or later
Structure of transceivers:
Triple RF Deck or Dual RF Deck structure
Caution
Do not connect a D-sub 25-pin cable to the transceiver while the FPU data for Mobile Relay Station is not written
in the transceiver. A D-sub 25-pin cable may malfunction if the D-sub 25-pin cable is connected to the transceiver
in this state.
FPU configuration
Various functions of
Mobile Relay Station
are configured, and the configuration data is written to the transceiver by using
KPG-D1/ D1N.
1
Configure “Mobile Relay Station” to a
PF
key or AUX Input port.
Note
When “Mobile Relay Station” is configured for the AUX Input port, configure for only
RF Deck Data
of 1 unit. If
“Mobile Relay Station” is configured for the AUX Input ports of
RF Deck Data
of 2 units, the behavior becomes
incorrect.
2
Configure the channel that behaves as a Mobile Relay Channel in
Mobile Relay Channel List
.
The channel for which the values in System Type, Channel Type, and Channel Spacing are the same as the other
channel needs to be configured as the Mobile Relay Channel. Also, configure both No.1 and No.2 RF Deck Data.
Figure 16-83 Mobile Relay Channel List
Note
0
Mobile Relay Station DB-25 Cable
can be configured when No.1 and No.2
RF Deck Data
are both configured.
0
In a Triple RF Deck structure,
RF Deck Data
of 2 random units can be selected and configured as Mobile Relay
Channels.
0
If a Mobile Relay Channel is not configured, the transceiver cannot enter Mobile Relay Station Mode.
16 MULTI RF DECK/ MULTI CONTROL HEAD
16.18 Relaying the Received Signal (Mobile Relay Station)
Common FUNC (K, F)/Ver 2.20
325
