Operating the transceiver
1
Press the
Channel Entry
key, or press the
Group ID/Channel Entry
key after selecting a zone other than an
NXDN Trunking system zone.
The transceiver enters Channel Entry Mode.
The following operations are identical even if the transceiver enters
Channel Entry Mode by using the keypad.
2
Enter the channel number.
The following are examples for entering a channel number by using the keypad.
0
If the maximum channel number has 3 digits:
To make a call on channel 250, press the
[2]
,
[5]
and
[0]
keys in this order.
To make a call on channel 90, press the
[0]
,
[9]
and
[0]
keys in this order.
To make a call on channel 7, press the
[0]
,
[0]
and
[7]
keys in this order.
0
If the maximum channel number has 2 digits:
To make a call on channel 90, press the
[9]
and
[0]
keys in this order.
To make a call on channel 7, press the
[0]
and
[7]
keys in this order.
0
If the maximum channel number has 1 digit:
To make a call on channel 7, press the
[7]
key.
If the maximum number of digits is entered, the transceiver exits Channel Entry Mode and then migrates to the
channel of the entered channel number.
3
Press the
Menu
(
[
]
) key.
The transceiver exits Channel Entry Mode and then migrates to the channel of the entered number.
If there is no channel of the entered channel number, a Key-entry Error Tone (1 beep) sounds from the transceiver,
and then the transceiver exits Channel Entry Mode.
OK
12 : 34
A
M
[ 001]
Channel No. ___
Low TX Power 1
Channel Entry
Note
0
Refer to “
” for key operations for entering the channel number in Channel Entry
Mode.
0
The channel number selected before the transceiver enters Channel Entry Mode appears on the display, such as “[001]”.
Pressing the
Menu
(
[
Q
]
) or
[*]
key while no channel number is entered causes the transceiver to exit Channel Entry Mode
and then to return to this channel number.
0
If the transceiver exits Channel Entry Mode by pressing the
Home
(
[
T
]
) key, the transceiver returns to the channel
selected before the transceiver entered Channel Entry Mode.
0
Pressing the
PTT
switch while in Channel Entry Mode causes the transceiver to transmit on the channel selected before
the transceiver entered Channel Entry Mode.
0
If the channel is changed while in Channel Entry Mode, pressing the
PTT
switch initiates transmission on the channel to
which the transceiver has changed.
0
If no key is pressed before the amount of time configured in
Mode Reset Timer
elapses, the transceiver exits Channel
Entry Mode and then returns to the channel selected before the transceiver entered Channel Entry Mode.
Configuration using KPG-D1/ D1N
Assigning functions to the
PF
keys on the transceiver (
Transceiver Settings > Key Assignment)
3 BASIC OPERATIONS
3.5 Changing the Zone-channel
Common FUNC (K, F)/Ver 2.20
43
