KEB COMBIVERT F5, Reference Manual, Page: 110 / 349

110
Parameters Descriptions
Control Setting: LC01...LC44
These parameters contain advanced adjustment parameters which
affect the motor gains, system inertia gains, pre-torque, etc.
Timer Parameters: LT01...LT31
These parameters adjust brake and drive signaling timers.
Positioning Parameters: LP01...LP23
These parameters contain the adjustments needed for the drive
positioning control.
Special Functions: LX01...LX25
These parameters allow advanced drive adjustments and facilitate
function tests of drive components.
Analog I/O: LA01...LA60
These parameter s define and adjust the analog inputs and outputs.
Outputs: LO01...LO32
These parameters define the functionality of the relay and solid-state
drive outputs.
Diagnostic Parameters: DG01...DG99 (Combivis only)
These parameters define the functionality of the relay and solid-
state drive outputs and are only viewable in Combivis, although most
should be available in the Diagnostics Screens.
Debug Parameter Group (DB): DB00...DB02 (Combivis only)
Displays the execution time of the timer interrupts that are used to
execute the software’s primary functions. This group is only visible
with Combivis.
Field Bus Configuration: FB01...FB55
These parameters define the settings for control with serial
communication data.
Terminal Slowdown: TS01...TS08
These parameters define the settings for NTSD inputs and speed
thresholds.
Not all parameters may be viewable and changeable, depending on the
password accessibility. Refer to Section 4.7.2 for additional informa-
tion on password access.
i