82 of 112
Operating the Reader Using the ReaderStart Software
⑥
Last antenna
the last antenna for the selected function
⑦
T
urn-off time
sets the time for how long the output is on for the
Tag found
and
Tag operation successful
function
⑧
Get
reads the curr
ent IO configur
ation settings
⑨
Set
sets the output settings
14.6.2 Test Input and Output
2
3
1
4
5
6
7
Fig. 46: GPIO: Test Input and Test Output
Test Input
Each input channel has two configur
ation parameters available:
①
Input 1
–
4
shows logical input 1–4; will only be shown if
Invert logical input
for the respective input has been
checked at
IO Configur
ation
(
① in
Fig.
45, p. 81
)
②
Read inputs
reads the inputs once
③
Read inputs
cyclic start/stop
reads the inputs in a loop/stops the reading
Test Output
④
Output
selects output 1–4 by means of the drop-down menu
►
In order to use this function, select the
Protocol access
function for the respective output (see
IO
Configuration, p. 81
and
Selecting Functions, p. 79
).
⑤
Duration
sets time in ms after which the output automatically returns to its idle mode either by moving the
bar or by entering the value
If the duration is set to its maximum value (65535), the output is permanently on.
⑥
Set output on
switches on the output
⑦
Set output off
switches off the output
