JUMO 709051, Operating Manual, Page: 9 / 92

V1.00/EN/00741192/2021-03-30 [IPC 300] 9
1 Introduction
1.1 Intended use
Read this operating manual before putting the device into service.
This operating manual is valid from device software version [389.01.01].
Keep the operating manual in a place that is accessible to all users at all times.
The device is designed for use in an industrial environment as specified in the
technical data. Other uses beyond those defined are not viewed as intended
uses.
The device has been manufactured in compliance with applicable standards
and directives as well as the applicable safety regulations. Nevertheless, im-
proper use may lead to personal injury or material damage.
To avoid danger, only use the device:
• For the intended use
• When in good order and condition
• When taking the technical documentation provided into account
Risks resulting from the application may arise, e.g. as the result of missing
safety provisions or wrong settings, even when the device is used properly
and as intended.
Separate safety switch-off required
The power controller produces the power that is needed at the analog input or
in manual mode. Safety systems independent of the power controller must be
installed. They should safely switch off the subsequent heating process in the
event of excess temperatures.
The power controller may only be operated using original JUMO semicon-
ductor fuses.
In the event of replacement, please check that the correct spare part has been
used.
All necessary settings are described in this operating manual.
Manipulations not described in the operating manual or expressly forbidden
will jeopardize your warranty rights.
If you have any problems, please contact the nearest branch office or the head
office.
E
When accessing the inner parts of the device and returning device plug-in
units, modules, or components, please observe the regulations according to
DIN EN 61340-5-1 and DIN EN 61340-5-2 "Protection of electronic devices
from electrostatic phenomena". Use only ESD packaging for shipment.
Please note that we cannot accept any liability for damage caused by ESD.
ESD=Electrostatic Discharge
B