JUMO 709051, Operating Manual, Page: 47 / 92

V1.00/EN/00741192/2021-03-30 [IPC 300] 47
4 Operation
4.2.5 Binary inputs
First of all, a setpoint changeover via digital inputs must be configured.
v
Chapter 5.1.7 "Binary inputs"
A setpoint value specified via the analog input, as set in Chapter 5.1.3, is
changed over to the value entered here (50 V), for example via Digital input 1.
0 to 1 to
9999.9 The switching differential at the minimum or maximum limit value
Current deviation from
Teach-In.
I.e. at > 0 %
the load has become
more high-resistance; at
< 0 % the load is more
low-resistance
0 to 10 to
100% Partial load failure or partial load short circuit:
The monitoring value for the percentage change to the load is set
(undercurrent or overcurrent).
By displaying the current deviation from the Teach-In value, it is
possible to check whether, for example, an output-level-depen-
dent resistance change is present.
By pressing the key, the current load state is applied as
the OK state for load monitoring.
A change in the load (load fault) will be evaluated by the de-
vice on the basis of this state.
k
/ bold = default setting
Value range Description
0 to 9999.9 Here the setpoint value is entered which is to become effective for the
changeover via a digital input.
k
/ bold = default setting