
5 Configuration
58
V1.00/EN/00741192/2021-03-30 [IPC 300]
5.1.8
Binary output
The digital output consists of a relay or an optocoupler, depending on the or-
der code.
With the digital output, it is possible to choose between the output mode "col-
lective fault transmitter",
or "Interf. signal".
v
Chapter 8.1 "Binary signal for collective fault"
The control direction is used to select the switching behavior of the relay and
determine whether, in the event of an error message, if it should switch on (er-
ror message via N/O contact) or drop out (error message via N/C contact). In
the optocoupler, the control direction determines whether the collector-emitter
loop should be conductive or high-impedance in the event of an error mes-
sage.
h
Use the
key
to switch to the configuration level
r
Digital output
Control direction,
digital input2
high inactive
The function for digital input 2 can be triggered for "high or low
switching level".
high active
Value / settings
Description
k
/ bold = default setting
Value /
settings
Description
Output mode
Collective
fault trans-
mitter
The digital output switches if a collective fault occurs on the device. This
can be configured as an "N/C contact" or as an "N/O contact" (see be-
low).
The K1 LEDs also light up in the event of a fault.
Interf. sig-
nal
The digital output is controlled via an interface
k
/ bold = default setting
Summary of Contents for 709051
